 |
|
 |
|
 |
|
Harb Ski Systems'
Canted Boot Sole Plates
|
Harb Ski Systems' molded boot sole plates simplify the task of canting (aligning) alpine ski boots... |
|||||||||
|
The sole plates are molded in half-degree increments, from 1 to 2.5 degrees. The generic design fits all boot brands.
[2 degrees shown] |
|||||||||
After determining the alignment that is needed on each
boot, the plates are simply screwed on to the toe and heel portions
of the boot sole... |
|||||||||
|
Plates installed...
|
|||||||||
|
The toe and heel lugs of the boot are cut down to DIN standard for thickness and parallelism with pre-positioned router tools. Using a dual-router setup makes the task quick and accurate.
|
|||||||||
Here is the completed installation... |
|||||||||
|
|
|||||||||
|
Harb Ski Systems can provide the plates, the router cutting tools, and training on how to implement this alignment system. Please contact us with any questions... Phone: 303-567-0679 E-mail: ask.us@harbskisystems.com |
|||||||||
 |
|
 |
|
 |
|
 |
|
 |
|
|
 |
|
|
 |
 |
|
 |
|
|
©1999-2002 Harb Ski
Systems, Inc.
"PMTS", "Primary Movements", and "Primary Movements
Teaching System" are trademarks of Harb Ski Systems, Inc.
"Direct Parallel"
is a Registered Trademark of Harb Ski Systems, Inc.
